[Previous][Next]
Code No.C1565: Engine revolution data invalid
 
 
caution
  • If there is any problem in the CAN bus lines, an incorrect diagnostic trouble code may be set. Prior to this diagnosis, diagnose the CAN bus lines (Refer to GROUP 54C, CAN Bus Diagnostics Table ).
  • Whenever ECU is replaced, ensure that the CAN bus lines are normal.
 
 
OPERATION
  • EPS-ECU receives engine revolution signal from the engine control module.
 
 
DIAGNOSTIC TROUBLE CODE SET CONDITIONS
If the microcomputer receives abnormal engine speed signal from the engine control module, it determines that the engine speed calculation system is defective.
 
 
PROBABLE CAUSES
  • Malfunction of CAN bus line
  • Malfunction of the EPS-ECU
  • Malfunction of the engine control module
 
 
DIAGNOSIS
STEP 1. Using scan tool MB991958, diagnose the CAN bus lines.
Use scan tool MB991958 to diagnose the CAN bus lines.
Is the check result normal?
Go to Step 3.
Repair the CAN bus lines (Refer to GROUP 54C - CAN Bus Diagnostics Table ). On completion, go to Step 2.
 
STEP 2. Diagnostic trouble code recheck after resetting CAN bus lines
(1) Erase the diagnostic trouble code.
(2) Turn the ignition switch from the LOCK (OFF) position to the ON position.
(3) Check if the diagnostic trouble code is set.
Is diagnostic trouble code C1565 set?
Go to Step 3.
This diagnosis is complete.
 
STEP 3. Using scan tool MB991958, check data list.
Check the following service data (Refer to ).
  • Item No. 07: Engine speed
Is the check result normal?
Go to Step 5.
Perform troubleshooting for engine control module (Refer to GROUP 13A - Troubleshooting/Inspection Chart for Diagnostic trouble code ). Then go to Step 4.
 
STEP 4. Check whether the diagnostic trouble code is set again.
(1) Erase the diagnostic trouble code.
(2) Turn the ignition switch from the LOCK (OFF) position to the ON position.
(3) Check if the diagnostic trouble code is set.
Is diagnostic trouble code C1565 set?
Replace the EPS-ECU (Refer to ). Then go to Step 5.
Intermittent malfunction (Refer to GROUP 00 - How to Cope with Intermittent Malfunction ).
 
STEP 5. Check whether the diagnostic trouble code is set again.
(1) Erase the diagnostic trouble code.
(2) Turn the ignition switch from the LOCK (OFF) position to the ON position.
(3) Check if the diagnostic trouble code is set.
Is diagnostic trouble code C1565 set?
Return to Step 1.
This diagnosis is complete.