[Previous][Next]
Code No. U1108 Meter CAN timeout
 
 
caution
  • If there is any problem in the CAN bus lines, an incorrect diagnostic trouble code may be stored. Prior to this diagnosis, diagnose the CAN bus lines (Refer to GROUP 54C - CAN Bus Diagnostics Table ).
  • If diagnostic trouble code U1108 is stored in ASC-ECU, always diagnose the CAN bus line. If there is any fault in the CAN bus lines, an incorrect diagnostic trouble code may be stored. In this case, the stored diagnostic trouble code is not highly reliable.
  • Before replacing the ECU, ensure that the communication circuit is normal.
  • When the hydraulic unit (integrated with ASC-ECU) is replaced, always carry out the calibration of the steering wheel sensor and the G and yaw rate sensor (Refer to and ).
 
 
OPERATION
The ASC-ECU communicates with the combination meter via the CAN bus lines.
 
 
DIAGNOSTIC TROUBLE CODE SET CONDITIONS
If the ACS-ECU cannot receive any signal from the combination meter for a predetermined period, this diagnostic trouble code will be stored.
 
 
PROBABLE CAUSES
  • The CAN bus line is defective.
  • Combination meter malfunction
  • Malfunction of ASC-ECU
 
 
DIAGNOSIS
STEP 1. Using scan tool MB991958, diagnose the CAN bus lines.
Use the scan tool MB991958 to diagnose the CAN bus lines.
Is the check result normal?
Go to Step 3.
Repair the CAN bus line. (Refer to GROUP 54C - Troubleshooting .) On completion, go to Step 2.
 
STEP 2. Diagnostic trouble code recheck after resetting CAN bus lines
Is diagnostic trouble code No. U1108 stored?
Go to Step 3.
This diagnosis is complete.
 
STEP 3. Use scan tool MB991958 to confirm a diagnostic trouble code of other systems.
Check whether a diagnostic trouble code is stored in the combination meter (Refer to GROUP 54A - Rear Combination light, Troubleshooting, Diagnostic Trouble Code Chart ).
Is the diagnostic trouble code stored?
Follow the relevant diagnostic trouble code procedure. Then go to Step 5.
Go to Step 4.
 
STEP 4. Use scan tool MB991958 to confirm a diagnostic trouble code of other systems.
Check whether a combination meter "time-out" related diagnostic trouble code is stored in other ECUs.
Is the diagnostic trouble code stored?
Replace the combination meter (Refer to GROUP 54A - Combination Meter ). Then go to Step 5.
Go to Step 5.
 
STEP 5. Check whether the diagnostic trouble code is stored again.
Check again if the diagnostic trouble code is stored.
(1) Erase the stored diagnostic trouble code.
(2) Ignition switch: "LOCK" (OFF)
(3) Ignition switch: "ON"
Is diagnostic trouble code No. U1108 stored?
Replace the hydraulic unit (integrated with ASC-ECU). (Refer to .)
The trouble can be an intermittent malfunction (Refer to GROUP 00 - How to Cope with Intermittent Malfunction ).