[Previous][Next]
DTC P0713: Malfunction of the transmission fluid temperature sensor (high voltage)
 
 
 
 
DIAGNOSTIC FUNCTION
TCM conducts fault detection by monitoring the terminal voltage of the transmission fluid temperature sensor.
 
 
DESCRIPTIONS OF MONITOR METHODS
  • TCM detects the fluid temperature -40°C (-40°F) or less for five seconds.
 
 
MONITOR EXECUTION
  • Vehicle speed: 10 km/h or more
 
 
MONITOR EXECUTION CONDITIONS (OTHER MONITOR AND SENSOR)
Other Monitor (There is no temporary DTC stored in memory for the item monitored below)
  • P0720: Abnormality in output speed sensor
Sensor (The sensor below is determined to be normal)
  • Output speed sensor
 
 
LOGIC FLOW CHARTS (Monitor Sequence)
 
 
DTC SET CONDITIONS
Check Conditions
  • After vehicle speed: 10 km/h (6.2 mph) or more.
  • Voltage of battery: 10 volts or more.
  • Voltage of battery: 16.5 volts or less.
Judgment Criteria
  • Value of temperature of transmission fluid: -40°C (-40°F) or less. (5 seconds)
 
 
OBD-II DRIVE CYCLE PATTERN
The vehicle is driven for at least 10 seconds at the speed of 20 km/h (12.4 mph) or more.
 
 
PROBABLE CAUSES
  • Malfunction of the valve body assembly (Faulty transmission fluid temperature sensor)
  • Damaged wiring harness and connectors
  • Malfunction of TCM
 
 
DIAGNOSIS
STEP 1. Check the following connector
  • CVT assembly connector
  • TCM connector
Check the terminals for a contact status problem and internal short circuit.
Is the check result normal?
Go to Step 2.
Repair the defective connector.
 
STEP 2. Check for open circuit in SPWR and SGND line between the CVT assembly connector and the TCM connector
Is the check result normal?
Go to Step 3.
Repair the wiring harness.
 
STEP 3. transmission fluid temperature sensor check
Refer to .
Is the check result normal?
Go to Step 4.
Replace the valve body assembly.
 
STEP 4. transmission fluid temperature sensor continuity check
Disconnect the CVT assembly connector, and then check that there is no continuity between the sensor-side terminal No. 12 and the transaxle case.
Is the check result normal?
Go to Step 5.
Replace the valve body assembly.
 
STEP 5. Symptom recheck after erasing diagnostic trouble code
Is the diagnostic trouble code stored?
Replace the TCM.
Intermittent malfunction (Refer to GROUP 00 - How to Cope with Intermittent Malfunctions .).