[Previous][Next]
DTC U0100: CAN Time-out Error (Engine)
 
 
 
 
DIAGNOSTIC FUNCTION
The TCM determines that the system is defective if the ECU can receive no CAN communication information from the engine control module.
 
 
DESCRIPTIONS OF MONITOR METHODS
  • TCM cannot receive the periodic communication data from the ECM.
 
 
MONITOR EXECUTION
  • Continuous
 
 
MONITOR EXECUTION CONDITIONS (OTHER MONITOR AND SENSOR)
Other Monitor (There is no temporary DTC stored in memory for the item monitored below)
  • Not applicable
Sensor (The sensor below is determined to be normal)
  • Not applicable
 
 
LOGIC FLOW CHARTS (Monitor Sequence)
 
 
DTC SET CONDITIONS
Check Conditions
  • Time after TCM start: more than 0.7 seconds.
  • Voltage of battery: 10 volts or more
  • Voltage of battery: 16.5 volts or less
Judgment Criteria
  • No information is received from the engine control module for 2.5 seconds.
 
 
OBD-II DRIVE CYCLE PATTERN
Ignition switch: ON (start the engine and keep it for 10 seconds or more)
 
 
PROBABLE CAUSES
  • Malfunction of the CAN bus line
  • Malfunction of Engine control module
  • Malfunction of TCM
 
 
DIAGNOSIS
STEP 1. M.U.T.-III CAN bus diagnostics
Use M.U.T.-III to perform the CAN bus diagnosis.
Is the check result normal?
Go to Step 2.
Repair the CAN bus lines (Refer to GROUP 54C - Troubleshooting, Diagnostic Trouble Code Chart ).
 
STEP 2. M.U.T.-III diagnostic trouble code
Check if the engine-related diagnostic trouble code is stored.
Is the engine-related diagnostic trouble code stored?
Carry out the appropriate troubleshooting.
Go to Step 3.
 
STEP 3. M.U.T.-III diagnostic trouble code
Is diagnostic trouble code No. U0100 stored in the other ECU, which communicates with the engine control module via CAN?
Is the diagnostic trouble code stored?
Go to Step 4.
Go to Step 5.
 
STEP 4. Symptom recheck after erasing diagnostic trouble code
Is the diagnostic trouble code stored?
Replace engine control module.
Intermittent malfunction (Refer to GROUP 00 - How to Cope with Intermittent Malfunctions .).
 
STEP 5. Symptom recheck after erasing diagnostic trouble code
Is the diagnostic trouble code stored?
Replace TCM.
Intermittent malfunction (Refer to GROUP 00 - How to Cope with Intermittent Malfunctions .).