[Previous][Next]
REMOVAL AND INSTALLATION
 
 
Removal steps
1.Main muffler
2.Seal ring
<<A>>>>A<<3.Heated oxygen sensor (rear)
4.Catalytic converter
5.Seal ring
6.Heat protector panel dash upper
•Gearshift cable and select cable assembly (Refer to GROUP 22A - Transaxle Control ) <M/T>.
•Transaxle control cable (Refer to GROUP 23A - Transaxle Control ) <CVT>.
7.Heat protector panel front floor front
8.Heat protector panel front floor rear
<<B>>•Engine room under cover side RH connection (Refer to GROUP 51 - Under Cover ).
9.Heat protector panel rear
 
 
REMOVAL SERVICE POINTS
 
 
<<A>> OXYGEN SENSOR REMOVAL
1. Remove the oxygen sensor connector connection and harness clamp.
2. Use special tool oxygen sensor wrench (MB991953) to remove the oxygen sensor.
 

 
 
<<B>> ENGINE ROOM UNDER COVER SIDE RH DISCONNECTION
Remove the nuts, bolts and clips at the right side of the engine compartment undercover in order to allow sufficient clearance to remove and install the heat protector panel rear.
 
 
 
 
INSTALLATION SERVICE POINT
 
 
>>A<< OXYGEN SENSOR INSTALLATION
1. In the same manner as removal, use special tool oxygen sensor wrench (MB991953) to tighten the oxygen sensor to the specified torque.
Tightening torque: 44 ± 5 N·m (32 ± 3 ft-lb)
2. Install the oxygen sensor connector connection and harness clamp.