| warning | When removing the fuel pipe, etc., release fuel pressure to prevent fuel spray. |
1. Remove the rear seat cushion assembly (Refer to GROUP 52A - Rear Seat Assembly 
). 2. Remove the inspection lid.
3. Disconnect the fuel tank pump and gauge assembly connector.
4. Crank the engine for at least two seconds.
5. If the engine is not started, turn the ignition switch to the "LOCK" (OFF) position.
6. If the engine is started, turn the ignition switch to the "LOCK" (OFF) position after the engine stopped.
7. Connect the fuel tank pump and gauge assembly connector.
8. Install the inspection lid.
9. Install the rear seat cushion assembly (Refer to GROUP 52A - Rear Seat Assembly ). ![[Previous]](../../../buttons/fprev.png)
![[Next]](../../../buttons/fnext.png)
)
)