1. Start the engine and allow it to warm up until the temperature of the engine coolant reaches 80 - 90°C (176 - 194°F).
2. | warning | Use care as engine oil could be hot. |
Remove the oil filler cap.
3. Remove the oil drain plug to drain engine oil.
4. Install a new oil drain plug gasket and then tighten the oil drain plug to the specified torque.Tightening torque: 39 ± 5 N·m (29 ± 3 ft-lb)
5. Refill with specified quantity of engine oil.- Specified Engine Oil: Engine oils displaying the ILSAC certification symbol ("Starburst" symbol) on the container. If these oils are not available, and API classification SN or higher can be used.
- Total quantity (Includes volume inside engine oil filter): 3.0 dm3 (3.11 quarts)
| note | SAE 0W-20 engine oil is strongly recommended for optimum fuel economy and cold starting. If SAE 0W-20 is not available, the ILSAC certification oil of other viscosity grades can be temporarily used. |
6. Install the oil filler cap.
7. Let the engine run for a few minutes.
8. Stop the engine, and then check the engine oil level using the engine oil dipstick after a few minutes.
![[Previous]](../../../buttons/fprev.png)
![[Next]](../../../buttons/fnext.png)
)
)