[Previous][Next]
Work Procedure [After Replacing Chassis Control Module]
1.WRITING MAC KEY
With M.U.T.-III SE
Perform MAC key writing. Refer to Description.
: .
 
2.PERFORM PROGRAMMING
With M.U.T.-III SE
Perform chassis control module programming according to the procedure of “Programming” in M.U.T.-III SE User's Manual. Refer to M.U.T.-III SE User's Manual.
cautionDuring programming, maintain the following conditions:
  • Electric motor switch: ON
  • Electric load: OFF
  • Brake pedal: Not depressed
  • 12V battery voltage: 12 – 13.5 V (Check the value displayed on the M.U.T.-III SE screen.)
: .
 
3.PERFORM CONFIGURATION
With M.U.T.-III SE
Perform configuration. Refer to Description.
: .
 
4.PERFORM NECESSARY WORK
  1. Perform Diagnostic Trouble Code for “CHASSIS CONTROL”.
  2. Erase the memory of Diagnostic Trouble Code results.
: End of work.