[Previous][Next]
System Description
 
 
SYSTEM DIAGRAM
ComponentDescription
PHEV-ECUGENERAL INFORMATION
BCMSystem Description
ABS actuator and electric unit (control unit)ABS Actuator and Electric Unit (Control Unit)
Combination meterCombination Meter
Side radar LH/RHSide Radar LH/RH
BSW indicator LH, RHBSW Indicator LH/RH
 
 
SIDE RADAR INPUT/OUTPUT SIGNAL ITEM
 
 
Input Signal Item
Transmit unitSignal nameDescription
PHEV-ECUCAN communicationShift position signalReceives a select lever position
ABS actuator and electric unit (control unit)CAN communication
Vehicle speed signal (ABS)Receives wheel speeds of four wheels
BCMCAN communicationTurn indicator signalReceives an operational state of the turn signal light and the hazard light
Dimmer signalReceives ON/OFF state of dimmer signal
Combination meterCAN communicationSystem selection signalReceives a selection state of each item selected with the information display
 
 
Output Signal Item
Reception unitSignal nameDescription
Combination meterCAN communicationMeter display signalTransmits a signal to display a state of the system on the information display
Buzzer output signalTransmits a signal to activate buzzer
BSW indicator LH, RHBSW indicator signalTransmits a BSW indicator signal to turn ON the BSW indicator
BSW indicator dimmer signalTransmits a BSW indicator dimmer signal to dimmer BSW indicator
 
 
FUNCTION DESCRIPTION
  • The Blind Spot Warning (BSW) system can help alert the driver of other vehicles in adjacent lanes when changing lanes.
  • The BSW system uses side radar installed near the rear bumper to detect vehicles in an adjacent lane.
  • The side radar can detect vehicles on either side of vehicle within the detection zone shown as illustrated.
  • The BSW system operates above approximately 10 km/h (6.2 mph).
  • If the side radar detects vehicles in the detection zone, the BSW indicator illuminates.
  • If the driver then activates the turn signal, a buzzer sounds twice and the BSW indicator blinks.
    noteA buzzer sounds if the side radar have already detected vehicles when the driver activates the turn signal. If a vehicle comes into the detection zone after the driver activates the turn signal, then only the BSW indicator blinks and no buzzer sounds.
 
 
OPERATION DESCRIPTION
  • Side radar enables BSW system.
  • The side radar turns on the BSW system when the turned ON by information display.
  • Side radar detects a vehicle in the adjacent lane.
  • Side radar starts the control as follows, based on a vehicle detection signal, turn signal and dimmer signal transmitted from BCM via CAN communication:
    • Transmits BSW indicator signal and BSW indicator dimmer signal to BSW indicator.
    • Transmits a buzzer output signal to combination meter.
 
 
OPERATION CONDITION
Side radar performs the control when the following conditions are satisfied.
  • BSW system: ON
  • Vehicle speed: Approximately 10 km/h (6.2 MPH) or more
note
  • ON/OFF of BSW system is performed with the information display.
  • The BSW system may not function properly, depending on the situation. Refer to Handling Precaution.
 
 
CANCEL CONDITION
The side radar cancels the operation when the system is under any conditions of the operation cancellation condition.
  • When the system malfunction occurs.
  • When the area around the side radar is dirty.