[Previous][Next]
DTC Description
 
 
DTC DETECTION LOGIC
DTC No.M.U.T.-III SE screen terms
(Trouble diagnosis content)
DTC detection condition
C1B8054Calibration not completed
(Calibration not completed)
Diagnosis conditionWhen electric motor switch is ON
Signal (terminal)-
ThresholdWhen calibration is not complete.
Diagnosis delay time1 second or less
 
 
POSSIBLE CAUSE
  • Incomplete programing of chassis control module
  • Chassis control module
 
 
FAIL-SAFE
The following functions are suspended.
  • Brake auto hold function
  • Drive mode selector function
  • Innovative operation mode function
 
 
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn the electric motor switch OFF and wait at least 10 seconds before conducting the next test.
: .
 
2.CHECK DTC DETECTION
With M.U.T.-III SE
  1. Turn the electric motor switch OFF to ON.
    cautionBe sure to wait of 10 seconds after turn the electric motor switch OFF or ON.
  2. Perform Diagnostic Trouble Code for “CHASSIS CONTROL”.
Is DTC “C1B80-54” detected?
Refer to Diagnosis Procedure.
-1To check malfunction symptom before repair: Refer to Intermittent IncidentIntermittent Incident.
-2Confirmation after repair: INSPECTION END