[Previous][Next]
DTC Description
 
 
DTC DETECTION LOGIC
DTC No. M.U.T.-III SE screen terms
(Trouble diagnosis content)
DTC detection condition
C1E83-62 BSW ON/OFF Incorrect
(Blind Spot Warning ON/OFF Incorrect)
Diagnosis condition When electric motor switch is ON
Signal (terminal) -
Threshold If side radar right is malfunctioning
Diagnosis delay time 5 seconds or more
 
 
POSSIBLE CAUSE
Side radar RH
 
 
FAIL-SAFE
The following systems are canceled.
  • BSW
  • Active Blind Spot Assist [ABSA]
  • RCTA
 
 
CONFIRMATION PROCEDURE
1.CHECK DTC PRIORITY
If DTC “C1E83-62” is displayed with Network-DTC, first diagnose the Network-DTC.
Is applicable DTC detected?
Perform diagnosis of applicable. Refer to DTC IndexDTC Index.
.
 
2.PERFORM DTC CONFIRMATION PROCEDURE
  1. Change the power supply mode of the electric motor switch to ON (READY indicator: ON).
  2. Perform “Read All DTCs” with M.U.T.-III SE.
  3. Check if the “C1E83-62” is detected as the current malfunction in "Diagnostic Trouble Code" of “Side radar (Rear right)”.
Is the “C1E83-62” detected as the current malfunction?
Refer to DTC Diagnosis ProcedureDiagnosis Procedure.
-1 To check malfunction symptom before repair: Refer to Intermittent IncidentIntermittent Incident.
-2 Confirmation after repair: INSPECTION END