[Previous][Next]
DTC Description
 
 
DTC DETECTION LOGIC
DTC No. M.U.T.-III SE screen terms
(Trouble diagnosis content)
DTC detection condition
U214E-87 CAN comm err (combination meter)
[Controller area network communication error (combination meter)]
Diagnosis condition When electric motor switch is ON
Signal (terminal) -
Threshold If front camera unit is not transmitting or receiving CAN communication signal
Diagnosis delay time 2 seconds or more
 
 
POSSIBLE CAUSE
CAN communication system
 
 
FAIL-SAFE
The following functions are suspended.
  • Vehicle-to-vehicle distance control mode
  • Conven tional (fixed speed) cruise control mode
  • Steering wheel assistance function
  • FCM
  • LDW
  • LDP
  • Active Blind Spot Assist [ABSA]
  • TSR
 
 
CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
  1. Change the power supply mode of the electric motor switch to ON (READY indicator: ON).
  2. Perform “Read All DTCs” with M.U.T.-III SE.
  3. Check if the “U214E-87” is detected as the current malfunction on the Diagnostic Trouble Code results of “LANE CAMERA”.
Is “U214E-87” detected as the current malfunction?
Refer to DTC Diagnosis ProcedureDiagnosis Procedure.
-1 To check malfunction symptom before repair: Refer to Intermittent IncidentIntermittent Incident.
-2 Confirmation after repair: INSPECTION END