[Previous][Next]
DTC Description
 
 
DTC DETECTION LOGIC
DTC No. M.U.T.-III SE screen terms
(Trouble diagnosis content)
DTC detection condition
C2507-17Power supply circuit
(Power supply circuit)
Diagnosis conditionWhen electric motor switch is ON
Signal (terminal)-
ThresholdFront camera unit ignition voltage is greater than 16.5 V
Diagnosis delay time1 seconds or more
 
 
POSSIBLE CAUSE
  • Harness, connector, or fuse
  • Front camera unit
  • Power supply circuit
 
 
FAIL-SAFE
The following functions are suspended.
  • Vehicle-to-vehicle distance control mode
  • Conven tional (fixed speed) cruise control mode
  • Steering wheel assistance function
  • FCM
  • LDW
  • LDP
  • Active Blind Spot Assist [ABSA]
  • TSR
 
 
CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
  1. Change the power supply mode of the electric motor switch to ON (READY indicator: ON).
  2. Perform “Read All DTCs” with M.U.T.-III SE.
  3. Check if the “C2507-17” is detected as the current malfunction on the Diagnostic Trouble Code results of “LANE CAMERA”.
Is “C2507-17” detected as the current malfunction?
Refer to DTC Diagnosis Procedure.
-1To check malfunction symptom before repair: Refer to Intermittent IncidentIntermittent Incident.
-2Confirmation after repair: INSPECTION END