[Previous][Next]
DTC Description
 
 
DTC DETECTION LOGIC
DTCM.U.T.-III SE screen terms
(Trouble diagnosis content)
DTC detection condition
C1F7649Steering angle sensor
(Steering angle sensor)
Diagnosis condition
  • READY indicator: ON
  • When FCM system is ON
Signal (terminal)—
ThresholdIf the steering angle sensor is malfunction
Diagnosis delay time2 seconds or more
 
 
POSSIBLE CAUSE
Steering angle sensor
 
 
FAIL-SAFE
The following systems are canceled.
  • Vehicle-to-vehicle distance control mode
  • Conventional (fixed speed) cruise control mode
  • Steering wheel assistance function
  • FCM
  • Rear AEB
  • PFCW
  • LDW
  • LDP
  • BSW
  • Active Blind Spot Assist [ABSA]
  • RCTA
  • TSR
  • DAA
 
 
CONFIRMATION PROCEDURE
1.CHECK DTC PRIORITY
If DTC “C1F76-49” is displayed with Network-DTC, first diagnose the Network-DTC.
Is applicable DTC detected?
Perform diagnosis of applicable. Refer to DTC IndexDTC Index.
.
 
2.PERFORM DTC CONFIRMATION PROCEDURE
  1. Change the power supply mode of the electric motor switch to ON (READY indicator: ON).
  2. Turn the FCM system ON.
  3. Perform “Read All DTCs” with M.U.T.-III SE.
  4. Check if the “C1F76-49” is detected as the current malfunction in Diagnostic Trouble Code results of “ICC/ADAS 2”.
Is “C1F76-49” detected as the current malfunction?
Refer to DTC Diagnosis Procedure.
-1To check malfunction symptom before repair: Refer to Intermittent IncidentIntermittent Incident.
-2Confirmation after repair: INSPECTION END