[Previous][Next]
DTC Description
 
 
DTC DETECTION LOGIC
DTC M.U.T.-III SE screen terms
(Trouble diagnosis content)
DTC detection condition
C1F05 49 Front camera unit
(Front camera unit)
Diagnosis condition READY indicator: ON
Signal (terminal)
Threshold If front camera unit is malfunctioning
Diagnosis delay time 1 second or less
noteDTC "C1F05-49" may be detected when M.U.T.-III SE is communicating with distance sensor since the control function of distance sensor is temporary stopped.
 
 
POSSIBLE CAUSE
Front camera unit
 
 
FAIL-SAFE
The following systems are canceled.
  • Vehicle-to-vehicle distance control mode
  • Conventional (fixed speed) cruise control mode
  • Steering wheel assistance function
  • FCM
  • LDW
  • LDP
  • Active Blind Spot Assist [ABSA]
  • TSR
 
 
CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
  1. Change the power supply mode of the electric motor switch to ON (READY indicator: ON).
  2. Perform “Diagnosis (One System)” of "ICC/ADAS 2" with M.U.T.-III SE.
    noteWhen performing "Read All DTCs", DTC “C1F05-49” may be detected because distance sensor stops its control function by communicating with M.U.T.-III SE. Therefore performing "Diagnosis (One System)" is necessary.
  3. Check if the “C1F05-49” is detected as the current malfunction in "Diagnostic Trouble Code" of “ICC/ADAS 2”.
Is “C1F05-49” detected as the current malfunction?
Refer to DTC Diagnosis ProcedureDiagnosis Procedure.
-1 To check malfunction symptom before repair: Refer to Intermittent IncidentIntermittent Incident.
-2 Confirmation after repair: INSPECTION END