Diagnosis Procedure
1.
CHECK BSW INDICATOR CIRCUIT FOR SHORT
Turn the electric motor switch OFF.
Disconnect side radar LH harness connector and BSW indicator harness connector.
Check continuity between side radar LH harness connector and ground.
Side radar LH
Ground
Continuity
Connector
Terminal
B461
6
Not existed
Is the inspection result normal?
.
Repair the harnesses or connectors.
2.
REPLACE THE SIDE RADAR
Replace the side radar.
Perform “Read All DTCs” with M.U.T.-III SE.
Check if the “C1E01-12” is detected in "Diagnostic Trouble Code" of “Side radar (Rear left)”
Is the DTC “C1E01-12” detected?
Replace the side radar LH. Refer to
Removal and Installation
.
INSPECTION END
![[Previous]](../../../buttons/fprev.png)
![[Next]](../../../buttons/fnext.png)
. 
Repair the harnesses or connectors. Replace the side radar LH. Refer to Removal and Installation. INSPECTION END