[Previous][Next]
DTC Description
 
 
DTC DETECTION LOGIC
DTC No.M.U.T.-III SE screen terms
(Trouble diagnosis content)
DTC detection condition
B2E12-55Configuration
(Configuration)
Diagnosis conditionWhen electric motor switch is ON
Signal (terminal)—
ThresholdConfiguration not complete
Diagnosis delay time1 second or more
 
 
POSSIBLE CAUSE
  • System configuration has not been made or is in complete.
  • TCU
 
 
FAIL-SAFE
TCU has not been initialized
 
 
DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
With M.U.T.-III SE
  1. Turn the electric motor switch ON.
  2. Turn the electric motor switch OFF and wait at least 30 seconds.
  3. Turn the electric motor switch ON and wait at least 30 seconds or more.
  4. Select “Diagnostic Trouble Code” mode of “IVC” using M.U.T.-III SE.
  5. Check DTC.
Is DTC B2E12‐55 detected?
Refer to Diagnosis Procedure.
-1To check malfunction symptom before repair: Refer toIntermittent Incident.
-2Confirmation after repair: INSPECTION END