[Previous][Next]
Diagnosis Procedure
1.CHECK LVDS CABLE 1
  1. Turn the electric motor switch OFF.
  2. Check the connection status of the LVDS cable connector. (around view monitor control unit side, wire to wire, and rear camera side)
Is inspection result normal?
.
Connect the LVDS cable connector correctly.
 
2.CHECK LVDS CABLE 2
  1. Turn the electric motor switch ON.
  2. Disconnect around view monitor control unit connector and rear camera connector.
  3. Check continuity between around view monitor control unit harness connector and rear camera harness connector.
    Around view monitor control unitRear cameraContinuity
    ConnectorTerminalsConnectorTerminals
    B8137D5201Existed
    382
  4. Check continuity between around view monitor control unit harness connector and ground.
    Around view monitor control unitGroundContinuity
    ConnectorTerminal
    B8137Not existed
Is inspection result normal?
Replace rear camera. Refer to Removal and Installation.
Replace LVDS cable.