Description
Vehicle specification needs to be written with M.U.T.-III SE because it is not written after replacing the around view monitor control unit.
The configuration requires network connection. M.U.T.-III SE connects to network and then it downloads the configuration data from the server. Then M.U.T.-III SE writes the vehicle specification to the around view monitor control unit.
| note | For details the network connection and operation, refer to “M.U.T.-III SE User's Manual”. The configuration no need to “save” configuration data from the around view monitor control unit. The configuration data is always generated freshly at the server and then downloaded to the M.U.T.-III SE. |
| caution | - Perform the procedures indicated in “Configuration”.
- Make sure to check that the chassis number matches. If a wrong number is written, the ECU may not operate normally.
- Perform “Configuration” only for new around view monitor control unit. If it is performed for old around view monitor control unit, the ECU may not operate normally.
|
![[Previous]](../../../buttons/fprev.png)
![[Next]](../../../buttons/fnext.png)
.