[Previous][Next]
DTC Description
 
 
DTC DETECTION LOGIC
DTC No.M.U.T.-III SE screen items
(Trouble diagnosis content)
DTC detection condition
B2FAF-14Ignition relay-2
(Ignition relay-2)
Diagnosis conditionWhen electric motor switch is OFF.
Signal (terminal)Ignition relay-2 control signal (terminal #33)
Threshold0 V
Diagnosis delay time1 second or more
 
 
POSSIBLE CAUSE
  • Harness or connectors (Ignition relay-2 control signal circuit is open or shorted to ground)
  • Ignition relay-2
  • BCM
 
 
FAIL-SAFE
—
 
 
DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
With M.U.T.-III SE
  1. Electric motor switch to ON.
  2. Electric motor switch to OFF and wait for 1 second or more.
  3. Electric motor switch to ON.
  4. Check "Diagnostic Trouble Code" of “BCM” using M.U.T.-III SE.
Is DTC detected?
Refer to Diagnosis Procedure.
-1 To check malfunction symptom before repair: Refer to Intermittent IncidentIntermittent Incident.
-2 Confirmation after repair: INSPECTION END