[Previous][Next]
Diagnosis Procedure
1.CHECK AIMING MOTOR DRIVE SIGNAL CIRCUIT (SHORT CIRCUIT)
  1. Electric motor switch is OFF.
  2. Lighting switch AUTO.
  3. Disconnect IPDM E/R connector and headlight connector.
  4. Check voltage between the IPDM E/R harness connector and ground.
(+)(-)Voltage
IPDM E/R
ConnectorTerminal
E21863GroundApprox. 0 V
Is the inspection result normal?
Repair or replace harness.
 
2.PERFORM DTC CONFIRMATION PROCEDURE
  1. Connect IPDM E/R and headlight connector.
  2. Electric motor switch is ON.
  3. Select “Diagnostic Trouble Code” mode of “IPDM E/R” using M.U.T.-III SE.
  4. Erase DTC.
  5. Electric motor switch is OFF.
  6. Perform DTC CONFIRMATION PROCEDURE. Refer toDTC Description.
Is DTC detected?
.
INSPECTION END
 
3.REPLACE HEADLIGHT
  1. Replace headlight. Refer toRemoval and Installation.
  2. Electric motor switch is ON.
  3. Select “Diagnostic Trouble Code” mode of “IPDM E/R” using M.U.T.-III SE.
  4. Erase DTC.
  5. Electric motor switch is OFF.
  6. Perform DTC CONFIRMATION PROCEDURE. Refer toDTC Description.
Is DTC detected?
Replace IPDM E/R. Refer to Removal and Installation.
INSPECTION END