[Previous][Next]
Removal and Installation
 
 
REMOVAL
 
 
1. Remove steering angle sensor. Refer to Removal and Installation.
2. Disconnect harness connector from combination switch.
3. Remove the combination switch mounting screw .
4. Pull out the combination switch by moving it alternately on the right and left side.
cautionNever deformation and damage the pawls.
: Pawl
 
 
INSTALLATION
Install in the reverse order of removal.
caution
  • Never reuse combination switch. Always replace it with a new one when it is removed.
  • Visually check the pawls for deformation and damage during installation. Replace with new ones if necessary.
  • Insert the combination switch so that the protrusion of the combination switch and the cut-out of the steering column match together.