[Previous][Next]
DTC Description
 
 
DTC DETECTION LOGIC
DTC No.M.U.T.-III SE screen items
(Trouble diagnosis content)
DTC Detection Condition
B2C95-64Combination switch
(Combination switch)
Diagnosis conditionElectric motor switch OFF (auto ACC status)
Signal (terminal)Combination switch signal
ThresholdBCM detects the combination switch check diode positions stuck at ON for 2 seconds or more
Diagnosis delay time2 seconds or more
 
 
POSSIBLE CAUSE
  • Harness or connector (combination switch circuit is short to battery)
  • Combination switch
  • BCM
 
 
FAIL-SAFE
Turns ON the headlight (LO)
 
 
DTC CONFIRMATION PROCEDURE
1.CHECK SELF DIAGNOSTIC RESULT
With M.U.T.-III SE
  1. Erase DTC.
  2. Electric motor switch OFF.
  3. Perform the "Diagnostic Trouble Code" of BCM with M.U.T.-III SE, when passed 2 seconds or more after the electric motor switch is turned OFF (auto ACC status).
Is DTC detected?
Refer to Diagnosis Procedure.
-1To check malfunction symptom before repair: Refer to Intermittent IncidentIntermittent Incident.
-2Confirmation after repair: INSPECTION END