[Previous][Next]
DTC Description
 
 
DTC DETECTION LOGIC
DTC No.Scan tool (M.U.T.-III SE) display items
(Trouble diagnosis content)
DTC Detection Condition
B2CB5–64Rear wiper
(Rear wiper)
Diagnosis conditionWhen the power supply mode of the electric motor switch is turned to ON.
Signal (terminal)Rear wiper stop position signal
ThresholdRear wiper stop position signal malfunction status between Rear wiper and BCM
Diagnosis delay timeDoes not change for more than 5 seconds
 
 
POSSIBLE CAUSE
  • Harness or connector (Rear wiper stop position circuit is open or shorted)
  • Rear wiper motor
  • BCM
 
 
FAIL-SAFE
Stop rear wiper power supply for 1 minute
 
 
DTC CONFIRMATION PROCEDURE
1.DTC CONFIRMATION
  1. Erase DTC.
  2. Electric motor switch ON.
  3. Rear wiper switch ON.
  4. Perform the "Diagnostic Trouble Code" of "BCM" with scan tool (M.U.T.-III SE), when passed 5 seconds or more after.
Is DTC detected?
Refer to Diagnosis Procedure.
–1To check malfunction symptom before repair: Refer to Intermittent IncidentIntermittent Incident.
–2Confirmation after repair: INSPECTION END