1. Inspect for badly rusted or faulty headlight assemblies.
2. These conditions must be corrected before a satisfactory adjustment can be made.
3. Inspect tire inflation, and adjust if it is necessary.
4. If the fuel tank is not full, place a weight in the trunk of the vehicle to simulate weight of a full tank [3 kg (6.6 lb) per gallon].
5. There should be no other load in the vehicle other than driver or substituted weight of approximately 68 kg (150 lb) placed in driver's position.
6. Thoroughly clean the headlight lenses.
7. | caution | Check that the round shaped marking is on the lens surface. |
Place the vehicle on a level floor, perpendicular to a flat screen 7.62 m (25.0 ft) away from the headlight center-marks on the headlight lens. 8. Lock vehicle sideways to allow vehicle to assume its normal position.
9. Bounce the front suspension through three (3) oscillations by applying the body weight to hood or bumper.
10. Set the distance between the screen and the headlight center marks of the headlight as shown in the illustration.
11. Four lines of adhesive tape (or equivalent markings) are required on screen or wall:(1) Position a vertical tape or mark so that it is aligned with the vehicle center line.
(2) Measure the distance from the headlight center position to the floor. Transfer the measurement to the screen. Horizontal tape or mark on the screen is for reference of vertical adjustment.
(3) Measure the distance from the center line of the vehicle to the center of each headlight. Transfer the measurement to the screen. Vertical tape or mark on the screen with reference to the center line of each headlight.
![[Previous]](../../../buttons/fprev.png)
![[Next]](../../../buttons/fnext.png)
)
)
)
)
)
)
)