[Previous][Next]
DTC Description
 
 
DTC DETECTION LOGIC
DTC No.Scan tool (M.U.T.-III SE) screen items
(Trouble diagnosis content)
DTC detection condition
B2033–4ADONGLE NG
(Dongle not good)
Diagnosis conditionElectric motor switch ON
Signal (terminal)CAN communication signal
ThresholdThe ID verification results NG
Diagnosis delay time1 second or more
 
 
POSSIBLE CAUSE
  • Harness or connector
    (The CAN communication line is open or shorted)
  • Keyless operation key unit
  • EPS control unit
 
 
FAIL-SAFE
—
 
 
CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
  1. Turn the power supply mode of the electric motor switch to ON.
  2. Select “Diagnostic Trouble Code” mode of “HANDS FREE MODULE” using scan tool (M.U.T.-III SE).
Is the DTC detected?
Refer to DTC Diagnosis Procedure.
-1To check malfunction symptom before repair: Refer to Intermittent IncidentIntermittent Incident.
-2Confirm after repair: INSPECTION END