[Previous][Next]
DTC Description
 
 
DTC DETECTION LOGIC
DTC No.Scan tool (M.U.T.-III SE) screen items
(Trouble diagnosis content)
DTC detecting condition
B2C20-14Starter control relay
(Starter control relay)
Diagnosis conditionElectric motor switch ON
Signal (terminal)Starter cut relay signal
ThresholdWhen BCM detects starter cut relay circuit is short to ground or open
Diagnosis delay time1 second or more
 
 
POSSIBLE CAUSE
  • Harness or connectors
    (Starter cut relay circuit is short to ground or open)
  • Starter cut relay
 
 
FAIL-SAFE
—
 
 
CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
  1. Press electric motor switch under the following conditions and wait 1 second or more.
    • Selector lever: In the P position.
    • Brake pedal: Depressed.
  2. Select “Diagnostic Trouble Code” mode of “BCM” using scan tool (M.U.T.-III SE).
Is the DTC detected?
Refer to DTC Diagnosis Procedure.
-1To check malfunction symptom before repair: Refer to Intermittent IncidentIntermittent Incident.
-2Confirmation after repair: INSPECTION END