Diagnosis Procedure
1.
PERFORM "REPROGRAMING"
With scan tool (M.U.T.-III SE)
Perform "ECU reprograming".
Erase DTC.
Turn the power supply mode of the electric motor switch to OFF.
Turn the power supply mode of the electric motor switch to ON.
Check “Diagnostic Trouble Code” mode of “HANDS FREE MODULE” using scan tool (M.U.T.-III SE).
Is DTC detected?
.
INSPECTION END
2.
REPLACE KEYLESS OPERATION KEY UNIT
Replace keyless operation key unit. Refer to
REMOVAL AND INSTALLATION
.
:
INSPECTION END
![[Previous]](../../../buttons/fprev.png)
![[Next]](../../../buttons/fnext.png)
With scan tool (M.U.T.-III SE)
.
INSPECTION END.