[Previous][Next]
DTC Description
 
 
DTC DETECTION LOGIC
DTC No.M.U.T.-III SE screen items
(Trouble diagnosis content)
DTC Detection Condition
U1CA3-08LIN communication 4
(Local interconnect network communication 4)
Diagnosis conditionREADY indicator: ON
Signal (terminal)LIN (heated seat) signal (terminal #45)
Threshold A/C amp. is not transmitting or receiving LIN communication with each seat heater
Diagnosis delay time2 seconds or more.
 
 
POSSIBLE CAUSE
  • Fuse
  • Harness or connectors (Seat heater circuit is open or short to ground)
  • Each seat cushion heater
  • A/C amp.
 
 
FAIL-SAFE
—
 
 
DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
With M.U.T.-III SE
  1. Change the power supply mode of the electric motor switch to ON (READY indicator: ON).
  2. Check “Self-diagnosis” of “HVAC” using M.U.T.-III SE.
Is DTC detected?
Refer to Diagnosis Procedure.
-1To check malfunction symptom before repair: Refer to Intermittent Incident.
-2Confirmation after repair: INSPECTION END