[Previous][Next]
DTC Description
 
 
DTC DETECTION LOGIC
DTC No.M.U.T.-III SE screen terms
(Trouble diagnosis content)
DTC detection condition
B24C6-14BLOWER MOTOR CONTROL open circuit
(Blower motor control open circuit)
Diagnosis conditionWhen electric motor switch is ON
Signal (Terminal)Front blower motor control signal circuit
ThresholdECU applied voltage ≦3V
Diagnosis delay timeAbout 0.1 seconds
 
 
POSSIBLE CAUSE
Harness or connector (Control circuits is open or shorted to ground)
 
 
FAIL-SAFE
—
 
 
DTC CONFIRMATION PROCEDURE
1.PERFORM DIAGNOSTIC TROUBLE CODE
With M.U.T.-III SE
  1. Change the power supply mode of the electric motor switch to ON (READY indicator: ON).
  2. Select “Diagnostic Trouble Code” mode of “HVAC” using M.U.T.-III SE.
  3. Check DTC.
Is DTC detected?
Refer to Diagnosis Procedure.
-1To check malfunction symptom before repair: Refer to Intermittent IncidentIntermittent Incident.
-2Confirmation after repair: INSPECTION END