Diagnosis Procedure
1.
PERFORM Diagnostic Trouble Code
With M.U.T.-III SE
Change the power supply mode of the electric motor switch to ON (READY indicator: ON).
Select “Diagnostic Trouble Code” mode of “HVAC” with M.U.T.-III SE.
Touch "Erase DTCs".
Turn the electric motor switch OFF.
Change the power supply mode of the electric motor switch to ON (READY indicator: ON).
Perform “DTC CONFIRMATION PROCEDURE”. Refer to
DTC Description
.
Is DTC detected again?
Replace rear air control. Refer to
Removal and Installation
.
INSPECTION END
![[Previous]](../../../buttons/fprev.png)
![[Next]](../../../buttons/fnext.png)
With M.U.T.-III SE
.
Replace rear air control. Refer to Removal and Installation.
INSPECTION END