[Previous][Next]
DTC Description
DTC No.M.U.T.-III SE screen terms
(Trouble diagnosis content)
DTC detection condition
C160496TORQUE SENSOR
(Torque sensor)
Diagnosis conditionWhen electric motor switch is ON.
Signal (terminal)Steering torque sensor signal
ThresholdWhen a malfunction is detected in power steering torque sensor.
Diagnosis delay time1 second or less
 
 
POSSIBLE CAUSE
  • Harness or connector
  • Power steering torque sensor
  • Power steering control module
 
 
FAIL-SAFE
Manual steering state
 
 
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
  1. Pull the parking brake switch.
    noteCheck the parking brake switch indicator is turn On.
  2. Electric motor switch OFF.
  3. Get out of the vehicle and close all doors.
  4. Wait 65 seconds.
    note
    • Check the parking brake switch indicator turn OFF.
    • If the rear brake caliper is heated, wait an hour so that parking brake switch indicator does not turn OFF.
: .
 
2.DTC REPRODUCTION PROCEDURE
With M.U.T.-III SE
  1. Start the engine.
    cautionNever drive the vehicle.
  2. Perform Diagnostic Trouble Code for “EPS/DAST 3”.
Is DTC “C1604-96” detected?
Proceed to diagnosis procedure. Refer to Diagnosis Procedure.
-1To check malfunction symptom before repair: Refer to Intermittent IncidentIntermittent Incident.
-2Confirmation after repair: INSPECTION END