[Previous][Next]
Work Procedure
cautionWhen performing the following operations, always use M.U.T.-III SE. (It cannot be performed by any means other than M.U.T.-III SE.)
  • Replacing ABS actuator and electric unit (control unit)
1.CHANGE OF SYSTEM MODE
With M.U.T.-III SE
  1. Select “ABS", “WORK SUPPORT", and “SYSTEM MODE CHANGE" according to this order.
    cautionNever operate the parking brake switch.
  2. Select “Mode 1"and Touch “OK".
  3. Check display item “Electric parking mode".
Is the inspection result “Mode 1"?
.
Perform change of system mode again.
 
2.PERFORM THE DIAGNOSTIC TROUBLE CODE
With M.U.T.-III SE
  1. Pull parking brake switch to activate electric parking brake.
  2. Push parking brake switch to release electric parking brake.
  3. Perform Diagnostic Trouble Code for “ABS".
Is malfunction detected?
Check the DTC. Refer to DTC Index.
INSPECTION END