[Previous][Next]
Removal and Installation
 
 
REMOVAL
 
 
1. Remove tires. Refer to Removal and InstallationRemoval and Installation.
2. Remove front wheel sensor from steering knuckle.
cautionNever rotate and never pull front wheel sensor as much as possible, when pulling out.
3. Remove front wheel sensor harness from the vehicle.
cautionNever twist or pull front wheel sensor harness, when removing.
 
 
INSTALLATION
Note the following, and install in the reverse order of the removal.
  • Check that there is no foreign material like iron powder or damage on inner surface of front wheel sensor mounting hole of steering knuckle and sensor rotor. Install after cleaning when there are foreign material like iron powder, or replace when there is a malfunction.
  • Never twist front wheel sensor harness when installing front wheel sensor. Check that grommet is fully inserted to bracket . Check that front wheel sensor harness is not twisted after installation.
    cautionCheck that front wheel sensor identification line faces toward the vehicle front.