[Previous][Next]
DTC Description
 
 
DTC DETECTION LOGIC
DTC Description
M.U.T.-III SE screen terms
(Trouble diagnosis content)
DTC detection condition
C18FA46EBA Calibration Failure
(Electric driven intelligent brake unit Calibration Failure)
Diagnosis conditionElectric motor switch ON
Signal (terminal)
ThresholdA malfunction is detected when the internal data of the electric driven intelligent brake unit cannot be read.
Diagnosis delay time
 
 
POSSIBLE CAUSE
  • Electric driven intelligent brake unit
 
 
FAIL-SAFE
Normal condition
 
 
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always electric motor switch OFF (Auto ACC function OFF) before conducting the next test.
:
 
2.CHECK DTC DETECTION
M.U.T.-III SE
  1. Connect the all connectors.
  2. Use the M.U.T.-III SE, then erase the DTC set in the "EBA".
  3. Change the power supply mode of the electric motor switch to ON from OFF without depressing the brake pedal.
  4. Use the M.U.T.-III SE, then check whether the DTC set in the "EBA".
Is DTC “C18FA-46” detected?
INSPECTION END