[Previous][Next]
DTC Description
 
 
DTC DETECTION LOGIC
DTC Description
M.U.T.-III SE screen terms
(Trouble diagnosis content)
DTC detection condition
C18EA01Driver Brake Wish Not Detectable
(Driver brake detection)
Diagnosis condition
  • Electric motor switch ON
  • Power supply voltage is normal
Signal (terminal)CAN communitcation signal
ThresholdThe abnormal brake fluid signal is received from the ABS actuator and electric unit.
Diagnosis delay timeWithin 1 second
 
 
POSSIBLE CAUSE
noteConfirm if DTC is PAST or CRNT. If DTC is CRNT, proceed with Diagnosis Procedure. If DTC is PAST, clear DTC. Do not replace the ABS actuator and electric unit (control unit) for a PAST DTC.
ABS actuator and electric unit (control unit)
 
 
FAIL-SAFE
Stop the following operations.
  • Regenerative brake function
 
 
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn the electric motor switch OFF (Auto ACC function OFF) before conducting the next test.
:
 
2.CHECK DTC DETECTION
M.U.T.-III SE
  1. Change the power supply mode of the electric motor switch to OFF (Auto ACC function OFF).
  2. Change the power supply mode of the electric motor switch is ON (READY indicator: ON)
  3. Perform Diagnostic Trouble Code for "EBA".
Is DTC “C18EA-01” detected?
INSPECTION END