[Previous][Next]
DTC Description
 
 
DTC DETECTION LOGIC
DTC Description
M.U.T.-III SE screen terms
(Trouble diagnosis content)
DTC detection condition
C18E118Motor
(Motor)
Diagnosis conditionElectric motor switch ON
Signal (terminal)
ThresholdA malfunction of the motor drive circuit inside the electric driven intelligent brake unit occurs.
Diagnosis delay time2 seconds or more
 
 
POSSIBLE CAUSE
  • Electric driven intelligent brake unit
 
 
FAIL-SAFE
Stop the following operations.
  • Boosting operation by electric driven intelligent brake unit
  • Regenerative brake function
  • 4-wheel automatic pressure application function operated due to external brake request (FCM, ACC, innovative pedal operation mode, etc.)
 
 
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always electric motor switch OFF (Auto ACC function OFF) before conducting the next test.
:
 
2.CHECK DTC DETECTION
M.U.T.-III SE
  1. Change the power supply mode of the electric motor switch to ON from OFF without depressing the brake pedal.
    cautionDo not set the vehicle to the READY status.
  2. Start the M.U.T.-III SE, then perform the Diagnostic Trouble Code of "EBA".
Is DTC “C18E1-18” detected?
INSPECTION END