1.CHECK IPDM E/R SYSTEM
With M.U.T.-III SEPerform Diagnostic Trouble Code for “IPDM E/R".
Is DTC detected?
.
2.CHECK ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT) POWER SUPPLY AND GROUND CIRCUIT
3.CHECK CONNECTOR AND TERMINAL
4.PERFORM DIAGNOSTIC TROUBLE CODE
With M.U.T.-III SE- Connect IPDM E/R harness connector.
- Connect ABS actuator and electric unit (control unit) harness connector.
- Connect 12V battery negative terminal.
- Erase Diagnostic Trouble Code result for “ABS".
- Electric motor switch OFF (Auto ACC function OFF).
- Electric motor switch ON.
note | Wait at least 10 seconds after electric motor switch ON. |
- Perform Diagnostic Trouble Code for “ABS".
Is DTC detected?
INSPECTION END