[Previous][Next]
Diagnosis Procedure
1.CHECK CONNECTOR
  1. Disconnect 12V battery negative terminal.
  2. Check the parking brake actuator (LH) harness connector for disconnection or looseness.
  3. Check the ABS actuator and electric unit (control unit) harness connector for disconnection or looseness.
Is the inspection result normal?
.
Repair / replace harness or connector. .
 
2.CHECK PARKING BRAKE ACTUATOR CIRCUIT (1)
  1. Disconnect the ABS actuator and electric unit (control unit) harness connector.
  2. Check the continuity between ABS actuator and electric unit (control unit) harness connector terminals.
    ABS actuator and electric unit (control unit)Continuity
    ConnectorTerminal
    E12513 – 12Existed
Is the inspection result normal?
.
.
 
3.CHECK PARKING BRAKE ACTUATOR CIRCUIT (2)
Check the continuity between parking brake actuator (LH) harness connector terminals.
TerminalContinuity
1 – 2Existed
Is the inspection result normal?
Repair/replace harness or connector.
Replace the rear brake caliper assembly (LH). Refer to Removal and Installation.
 
4.CHECK MOTOR POWER SUPPLY
  1. Connect 12V battery negative terminal.
  2. Check the voltage between ABS actuator and electric unit (control unit) harness connector and ground.
    +Voltage
    ABS actuator and electric unit (control unit)
    ConnectorTerminal
    E12530Ground10 − 16 V
Is the inspection result normal?
.
.
 
5.CHECK MOTOR POWER SUPPLY CIRCUIT
  1. Disconnect 12V battery negative terminal.
  2. Check the 50A fuse (#L).
  3. Check the continuity and short circuit between ABS actuator and electric unit (control unit) harness connector terminal (30) and 50A fuse (#L).
Is the inspection result normal?
Perform trouble diagnosis for 12V battery power supply.
Repair/replace harness, connector or fuse.
 
6.CHECK ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT) GROUND CIRCUIT
  1. Disconnect 12V battery negative terminal.
  2. Check the continuity between ABS actuator and electric unit (control unit) harness connector and ground.
    ABS actuator and electric unit (control unit)Continuity
    ConnectorTerminal
    E12546GroundExisted
Is the inspection result normal?
.
Repair / replace harness or connector. .
 
7.CHECK TERMINAL
  1. Check parking brake actuator (LH) terminals for damage or loose connection with harness connector.
  2. Check ABS actuator and electric unit (control unit) terminals for damage or loose connection with harness connector.
the inspection result normal?
.
Repair/replace harness, connector or terminal. .
 
8.PERFORM DIAGNOSTIC TROUBLE CODE
With M.U.T.-III SE
  1. Connect the parking brake actuator (LH) harness connector.
  2. Connect the ABS actuator and electric unit (control unit) harness connector.
  3. Connect 12V battery negative terminal.
  4. Electric motor switch ON.
  5. Apply and release the parking brake five times.
  6. Perform Diagnostic Trouble Code for “ABS".
Is DTC “C10B1-01" detected?
-1"Active DTC" is displayed: Replace the ABS actuator and electric unit (control unit). Refer to Removal and Installation.
-2"Stored DTC" is displayed: INSPECTION END (Erase the memory of Diagnostic Trouble Code results.)
INSPECTION END