[Previous][Next]
Diagnosis Procedure
1.Check data monitor
M.U.T.-III SE
  1. Start the M.U.T.-III SE, then select "EBA" and "Data List" in order.
  2. Check "Battery Voltage".
Is the inspection result normal?
Check the 12V battery.
 
2.Checking connector terminal
  1. Change the power supply mode of the electric motor switch to OFF, then disconnect the M.U.T.-III SE from the data link connector.
  2. Close all the doors including the back door, then confirm that the room light turns off and wait for 3 minutes or more outside the vehicle in that state.
    cautionWhile waiting, do not touch the vehicle.
  3. Disconnect the 12V battery negative terminal (Refer to Precautions for Removing Battery Terminal).
  4. Disconnect the wiring harness and connectors of the electric driven intelligent brake unit and brake pedal stroke sensor. Then check that there is no failure on the pin terminal and its connection, and check that the connector terminal is not deformed or deteriorated.
Is the inspection result normal?
Repair / replace harness or connector.
 
3.PERFORM SELF-DIAGNOSIS
  1. Connect the all connectors.
  2. Use the M.U.T.-III SE, then erase the DTC set in the "EBA".
  3. Change the power supply mode of the electric motor switch to ON from OFF without depressing the brake pedal.
  4. Use the M.U.T.-III SE, then check whether the DTC set in the "EBA".
Is DTC “C18EC-12” detected?
INSPECTION END
 
4.Check the wiring harness between the electric driven intelligent brake unit and brake pedal stroke sensor
Measure the resitance between the following terminals.
Electric driven intelligent brake unitBrake pedal stroke sensorResistance
ConnecterTerminalConnecterTerminal
E4174E4162Continuity exists (2 Ω or less)
191
54
253
Is the inspection result normal?
Repair / replace harness or connector.
 
5.PERFORM SELF-DIAGNOSIS
  1. Connect the all connectors.
  2. Use the M.U.T.-III SE, then erase the DTC set in the "EBA".
  3. Change the power supply mode of the electric motor switch to ON from OFF without depressing the brake pedal.
  4. Use the M.U.T.-III SE, then check whether the DTC set in the "EBA".
Is DTC “C18EC-12” detected?
Replace the electric driven intelligent brake unit (Refer to Exploded View).
INSPECTION END