[Previous][Next]
WORK PROCEDURE
 
 
Description
When replacing the electric driven intelligent brake unit, the procedures of AFTER REPLACEMENT must be performed.
 
 
Work Procedure [After Replace electric driven intelligent brake unit]
1.PERFORM PROGRAMMING
With M.U.T.-III SE
Perform electric driven intelligent brake unit programming according to the procedure of “ECU reprogramming" in M.U.T.-III SE User's Manual. Refer to M.U.T.-III SE User's Manual.
cautionDuring programming, maintain the following conditions:
  • Electric motor switch: ON
  • Electric parking brake: Apply
  • Electric load: OFF
  • Brake pedal: Not depressed
  • 12V battery voltage: 12 – 13.5 V (Check the value displayed on the M.U.T.-III SE screen.)
: End of work.