[Previous][Next]
Removal and Installation
 
 
REMOVAL
 
 
1. Remove driver's side knee air bag module. Refer to Removal and Installation.
2. Disconnect the stop light switch harness connectors.
3. Rotate the stop light switch counterclockwise to remove.
4. Disconnect the accelerator pedal harness connector.
5. Remove the accelerator pedal from the brake pedal assembly. Refer to ACCELERATOR PEDAL REMOVAL AND INSTALLATION.
6. Remove nuts , and then remove bracket .
7. Remove snap pin and clevis pin from clevis of brake booster .
8. Remove harness clip from brake pedal.
9. Remove the brake pedal assembly.
cautionHold the brake booster and master cylinder assembly so as not to drop out or contact them other parts.
10. Perform inspection after removal. Refer to Inspection and Adjustment.
 
 
INSTALLATION
Note the following, and install in the reverse order of removal.
  • Never reuse the clevis pin and snap pin.
  • Apply the multi-purpose grease to the clevis pin and the mating faces. (Not necessary if grease has been already applied)
    noteThe clevis pin may be inserted in either direction.
  • Never impact brake pedal such as drop and interference with tools and parts.
  • Replace brake pedal when impacting brake pedal.
  • Perform adjustment after installation. Refer to Inspection and Adjustment.