[Previous][Next]
Refilling
caution
  • Turn the electric motor switch OFF and disconnect the harness connector of the electric driven intelligent brake unit and the ABS actuator and electric unit (control unit), or the battery negative terminal before performing work.
  • Never spill or splash brake fluid on painted surfaces. Brake fluid may seriously damage paint. Wipe it off immediately and wash with water if it gets on a painted surface. For brake component parts, never wash them with water.
 
 
1. Check that there is no foreign material in the reservoir tank, and refill with new brake fluid.
caution
  • Never reuse drained brake fluid.
  • Never allow foreign matter (e.g. dust) and oils other than brake fluid to enter the reservoir tank.
2. Loosen the bleeder valve, slowly depress the brake pedal to the full stroke, and then release the pedal. Repeat this operation at intervals of 2 or 3 seconds until new brake fluid is discharged. Then close the bleeder valve with the brake pedal depressed. Repeat the same work on each wheel.
3. Perform the air bleeding. Refer to Bleeding Brake System.