[Previous][Next]
DTC Description
 
 
DTC DETECTION LOGIC
DTC No.Scan tool (M.U.T.-III SE) screen terms
(Trouble diagnosis content)
DTC detection condition
C17147BLow tire pressure RL
(Low tire pressure rear left)
Diagnosis conditionDrive at a speed of 40 km/h (25 mph) or more reaches 10 minutes in total.
Signal (terminal)Tire pressure sensor signal.
ThresholdRear left tire air pressure drops to Approx. 75% or less from the specified value.
Diagnosis delay time10 minutes or more.
note
  • DTC may be detected depending on a tire pressure change caused by a seasonal air temperature change.
  • The low tire pressure warning light may be OFF due to an increase in tire internal temperature, resulted from driving.
 
 
POSSIBLE CAUSE
  • Rear left tire air pressure is low
  • Air leak because of rear left wheel change
 
 
DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION
With scan tool (M.U.T.-III SE)
  1. Turn the power supply mode of the electric motor switch to ON (READY indicator: OFF).
  2. Check the tire pressure for all wheels and adjust to the specified value. Refer to Tire Air Pressure.
  3. Perform "Diagnostic Trouble Code" of "BCM".
  4. Drive the vehicle at 40 km/h (25 mph) or more reaches 10 minuets in total.
Is DTC "C1714-7B" detected?
Refer to Diagnosis Procedure.
-1To check malfunction symptom before repair: Refer to Intermittent IncidentIntermittent Incident.
-2Confirmation after repair: INSPECTION END