[Previous][Next]
Disposal
 
 
1. Set strut assembly horizontally to the ground with the piston rod fully extracted.
2. Drill 2 – 3 mm (0.08 – 0.12 in) hole at the position () from top as shown in the figure to release gas gradually.
caution
  • Wear eye protection (safety glasses).
  • Wear gloves.
  • Be careful with metal chips or oil blown out by the compressed gas.
note
  • Drill vertically in this direction show by arrow.
  • Directly to the outer tube avoiding brackets.
  • The gas is clear, colorless, odorless, and harmless.
A: 20 – 30 mm (0.79 – 1.18 in)
3. Position the drilled hole downward and drain oil by moving the piston rod several times.
cautionDispose of drained oil according to the law and local regulations.