[Previous][Next]
DISASSEMBLY AND ASSEMBLY
cautionThe rear transaxle assembly cannot be disassembled.
 
 
Disassembly steps
1.Breather hose
2.Oil seal
3.Oil seal
4.Filler plug
5.Gasket
6.Drain plug
7.Gasket
    Required special tools:
  • MD998800: Oil seal installer
 
 
ASSEMBLY SERVICE POINTS
 
 
>>A<< OIL SEAL INSTALLATION
1. Use the special tool oil seal installer (MD998800) to install the oil seal to the transaxle case.
2. Apply ATF to the oil seal lip.
 
 
>>B<< OIL SEAL INSTALLATION
1. Use the special tool oil seal installer (MD998800) to install the oil seal to the transaxle housing.
2. Apply ATF to the oil seal lip.
 
 
>>C<< BREATHER HOSE INSTALLATION
cautionRemove any oil from the nipple prior to installing the breather hose.
1. Connect the breather hose to the nipple of the transaxle case.
noteInsert the breather hose completely up to the location marked on the nipple.
2. Connect the breather hose to the nipple of the transaxle housing.
noteInsert the breather hose completely up until it touches the transaxle housing.