DRIVE BATTERY REFRIGERANT TEMPERATURE SENSOR CHECK
Required Special Tools:
MB991223: Wiring harness set
MB992006: Extra fine probe
1.
Measure the resistance between the following terminals of the battery cooler pipe assembly connector.
Terminal
Standard value
1
2
At –10°C (14°F): 9.747 to 10.03 kΩ
At 25°C (77°F): 2.124 to 2.212 kΩ
At 60°C (140°F): 0.607 to 0.648 kΩ
7
8
2.
If the check result deviates from the standard value, replace the battery cooler pipe assembly (Refer to
SERVICE PROCEDURE
)
![[Previous]](../../../buttons/fprev.png)
![[Next]](../../../buttons/fnext.png)
)
)