[Previous][Next]
DTC No. U226B-87 Lost Communication With FrCam
 
 
 
 
DTC SET CONDITION
Check Condition
  • The power supply mode of the electric motor switch is ON.
Judgment Criterion
  • The CAN signal from the front camera unit can not be received for 2 seconds or more.
 
 
TROUBLESHOOTING HINTS
  • Malfunction of the CAN bus line (drivetrain CAN1, chassis CAN3, ITS CAN1, ITS CAN2, ITS CAN4)
  • Malfunction of the chassis control module power supply circuit
  • Malfunction of the chassis control module
  • Malfunction of the 8CH CAN gateway power supply circuit
  • Malfunction of the 8CH CAN gateway
  • Malfunction of the ADAS control unit 2 power supply circuit
  • Malfunction of the ADAS control unit 2
  • Malfunction of the front camera unit power supply circuit
  • Malfunction of the front camera unit
  • Malfunction of the PHEV-ECU
 
 
DIAGNOSIS
Required Special Tools:
  • MB992744: Vehicle communication interface-Lite (V.C.I.-Lite)
  • MB992745: V.C.I.-Lite main harness A
  • MB992747: V.C.I.-Lite USB cable short
  • MB992748: V.C.I.-Lite USB cable long
1.M.U.T.-IIISE other DTC
Check whether the PHEV-ECU sets the following DTC.
  • DTC No. U2276-87 Lost Communication With CDM
Is the DTC set?
Troubleshoot the set DTC (Refer to DTC No. U2276-87 Lost Communication With CDM).
 
2.Check whether the DTC is set again.
Is the DTC set?
Diagnose the CAN bus line (Refer to CAN Fundamental - Trouble Diagnosis Flow Chart Trouble Diagnosis Flow Chart).
The trouble can be an intermittent malfunction (Refer to General Information - How to Use Troubleshooting/Inspection Service Points, How to Cope with Intermittent Malfunctions HOW TO COPE WITH INTERMITTENT MALFUNCTIONS).