HOW TO TREAT PAST TROUBLE
Since the trouble may still be present even the status is "Stored", set the vehicle to the DTC detection condition and check that the status changes to "Active". If the status does not change from "Stored", carry out the following procedure.
1. Establish from the customer whether a fuse or connector has been replaced or disconnected.
2. If yes, erase the DTC, and then check that no DTC is set again. If no DTC is set, the diagnosis is complete.
3. If no, follow the applicable Diagnostic Trouble Code Chart. Then check the wiring harness and connector, and refer to "How to Cope with Intermittent Malfunctions HOW TO COPE WITH INTERMITTENT MALFUNCTIONS
." ![[Previous]](../../../buttons/fprev.png)
![[Next]](../../../buttons/fnext.png)