SUPPORT LOCATIONS FOR LIFTING AND JACKING
SUPPORT POSITIONS FOR A GARAGE JACK
| caution | - Be sure to support the specified locations only. Otherwise, deformation of vehicle may occur.
- Be careful to avoid damage to the front under cover or rear differential carrier assembly.
|
SUPPORT POSITIONS FOR RIGID RACKS, SINGLE-POST LIFT OR DOUBLE-POST LIFT
| caution | - If rubber attachments with grooves that are too thick are used at the front support positions, the front fender may become bent, so be sure to use rubber attachments with groove thicknesses of 18 mm (0.7 inch) or less.
- If attachments which are not high enough are used, they may damage areas such as the side step. Be sure to use attachments which are high enough, or remove the side step if not using attach ments.
|
PLATE TYPE LIFT
| caution | - Be sure to support the specified locations only. Otherwise, deformation of vehicle may occur.
- Be careful to avoid damage to the side sill garnish.
|
Support the notch with a spacer [100 mm (3.9 inch) width, 100 mm (3.9 inch) height and 200 mm (7.9 inch) depth]
![[Previous]](../../../buttons/fprev.png)
![[Next]](../../../buttons/fnext.png)
)
)
)